MOTOGADGET M-UNIT BASIC DIGITAL CONTROL UNIT NEW Fuse Box MG4002035

Description

Motogadget m.unit
Basic
Digital Control And Fuse Box
Within the DIY rewire-your-whole-bike food chain, the m-Unit Basic is an evolutionary step forward from the very popular m-Unit V2 and it only lacks the Bluetooth functionality found on the m-Unit Blue. All told, there's 12 input channels on one side then 10 output channels on the other. Designing electrical circuits and wiring up your bike is still a difficult task, however the m-Unit Basic makes it easy as it can be since it has been specifically engineered for the task. With the m-Unit Basic, circuits are digitally monitored -this means if you have an overload somewhere, the circuit will be tripped and an LED next to your output will flash. Correct the issue, re-cycle the m-Unit and get back on the road.
Features:
Complete digital control using buttons possible with 4 or 5-button operation
Complete replacement for the fuse box
10 independent circuits are digitally monitored and switched off if there are faults, after the fault is rectified, the safety function is automatically reset
Integrated alarm system that can be installed in any position.
Integrated, digital flasher relay that is load-independent; automatic switch-off optional and can be set; m.wave mode can be selected
Integrated hazard warning light
Turn signal can optionally be set as a positioning light
Integrated parking light and headlight flashing
Lo-beam and Hi-beam (up to 200 W switched capacity) can be controlled using only one button
Integrated, digital brake light modulator; flashing mode can be programmed
Acceleration-controlled emergency brake light (automatic warning signal)
Integrated starter relay for the starter system with solenoid (up to 30A switched capacity)
Intelligent and configurable management/switch-off of power consuming devices so that the maximum starting energy from the battery can be used when starting the motorbike
Integrated digital horn relay
Two configurable additional outputs AUX1 and AUX2
Diagnostics function for assigning inputs, outputs, the circuit switching status, short circuit diagnostics etc
Calibration and current measurement enables faults to be detected on all lamps
Specifications:
101mm L x 61mm W x 28mm H (3.97" L x 2.40" W x 1.10" H)
Fasteners: 2 x M5 stainless steel bolts (installation and ground connection), 1 x M5 screwing contact for battery Plus
Operating voltage: 6 V - 20 V
Operating temperature: -20°... +80°C
Made in Germany
Inputs:
1 x input (+12 V switched) for ignition lock or m.lock
11 x control input (minus/switched to ground) for:
Left turn signal
Right turn signal
Lo/Hi-beam
Starter
Horn
Brakelight
Kill switch
Stand switch
LIN bus
AUX1
AUX2
Outputs:
10 x Outputs (+12V) for:
Left turn signal
Right turn signal
Lo-beam
Hi-beam
Starter
Horn
Brakelight
Ignition
AUX1
AUX2
Includes:
m.Unit Basic
1 x M5 stainless steel bolt
2 x M5 stainless steel bolts with nut
Detailed installation and operating instructions
Cable kit no longer included
Attention international buyers, we are not responsible for import duties, taxes our vat on shipments. The Buyer is responsible for those costs and should account for them when purchasing. Shipping fees paid to us (A&J Cycles) does not cover these costs.